Screen & Pool Cage Repair in Hernando & Pasco Counties, FL

We repair the panels we can safely reach from a ladder—the side walls, screen doors, and lower roof panels—which covers the large majority of torn-screen jobs. A complete cage rescreen that includes the high roof and peak panels needs a lift or scaffolding, so we refer those to a dedicated screen enclosure company and handle the reachable repairs ourselves. Most single-panel repairs take 1-2 hours on site.

We use 18x14 mesh fiberglass screen as the standard, which offers good visibility and airflow. For homes with pets, we install pet-resistant polyester screen that's roughly seven times stronger than standard fiberglass. We also carry 20x20 no-see-um mesh for lanais and porches where tiny insects are a problem.

Minor bends in reachable aluminum frame members can usually be straightened on site, and we can replace a corroded or kinked section of a reachable member with matching stock. Anything beyond that—severely damaged cages, multiple structural failures, or a full frame rebuild—is a job for a screen enclosure specialist, and we'll point you to one rather than take it on.

Standard fiberglass screen in Hernando County typically lasts 7-10 years before UV degradation makes it brittle and prone to tearing. Pet-resistant screen lasts longer—often 12-15 years—because the polyester fibers resist UV breakdown better. You'll know it's time when the mesh tears easily with light finger pressure or has visible sagging between spline channels.

Absolutely. Window screen repair uses the same materials and techniques as pool cage work—just on a smaller frame. We can rescreen existing frames on site or build new aluminum frames if the originals are bent or corroded. Most window screens take about 20-30 minutes each.

Standard 18x14 mesh does not block no-see-ums—the openings are too large. You need 20x20 no-see-um mesh, which has tighter weave that blocks those tiny insects. The tradeoff is slightly reduced airflow and visibility, but most homeowners in Hernando County find it well worth the upgrade on enclosed lanais.

Old spline is always replaced during a rescreen—it's never reused. The rubber spline hardens and shrinks over time, especially in Florida heat, which is usually why screens pop out during storms. We match the correct spline diameter to your frame's channel width, which keeps the screen taut and secure.