Professional Light Fixture Replacement in Brooksville, FL

We replace existing light fixtures where there is already a junction box and wiring in place — flush mounts, chandeliers, vanity lights, wall sconces, and recessed light trim. All wire connections are performed by a licensed electrician we coordinate with. We handle the physical mounting, assembly, and finishing.

Under Florida law (FL 489.503), any wired electrical connection requires a licensed electrician, even if it is just connecting two wires. We coordinate with a licensed electrician who handles the wire connections while we handle everything else — removal, mounting, assembly, and cleanup.

Most fixture swaps take 30 to 60 minutes including the electrician's portion. Chandeliers and multi-light fixtures take longer due to assembly. We schedule the electrician to arrive at the same time so there is no waiting around.

New fixture locations require running new wiring, which is electrical work that must be done by a licensed electrician and may require a permit. We can coordinate the full job, but our role is limited to the mounting and finishing — the electrical rough-in is done by the electrician.

Dimmer switch installation involves wire connections, so it falls under the electrician's scope. We can coordinate this as part of the fixture replacement visit so both get done in one trip.

A good rule of thumb: add the room dimensions in feet (length plus width) and that number in inches is your ideal fixture diameter. A 12-by-14-foot room works well with a 26-inch fixture. We can advise on sizing when you are shopping.